Minoura Wheel Display Attachment 3 Uživatelský manuál stáhnout pdf

Wheel Display Attachment

WA-3

instructions manual

(ver.1.0 2012/2)

- 1 -

Important Notices

• For displaying a pair of bicycle wheel set only. Do

not use for any other purpose.

• Fits 9mm quick release and standard nut type hub

axles. Any thru axle type hub is not compatible.

• When installing WA-3 on the pillar, you need to

disassemble the clamp and re-assemble it with

proper procedure. Follow the instructions below.

• The clamp is designed to t the tube diameter

between 38mm (1-1/2") and 45mm (1-3/4"). When

installing on 43mm (1-5/8") or smaller diameter,

use the gray plastic shim in the clamp arms.

• When installing the wheel with 9mm quick release

skewer, the nut side must be put on the arm.

Opposite direction should give damage to the

acorn spring. Ideally, you should put a spacer

between the hub and the quick lever side for better

balance.

• Max load on WA-3 is 4 kgs.

How To Assemble

Wind the clamp arm

around the pillar.

Make sure that the

single-arm is located

the right side and the

double-arm is located

on the left side.

Install the supplied plastic

shim in the clamp only

when installing on 43mm

or smaller diameter pillar.

Make sure the parallel

ribs are located on the

single-arm side.

Pillar

(larger

diameter)

Put the shim

Put the Pivot Pin through all

three (3) holes of the clamp from

the bottom.

Screw the Pivot Pin Fixing Screw

with a flat washer into the pin.

If you have put the Pivot

Pin from top side, you

will not be able to screw

it with a hex wrench.

Do not rmly tighten

the Pivot Pin Fixing

Screw yet, otherwise the

next step will become

difcult.

The following explanation focuses on the clamp only,

so we don't show the attachments here.

Required Tools: 1 x M5 Hex Wrench

Pivot Pin Fixing Screw

Flat Washer

Pivot Pin

Clamp Tightening

Screw

Clamp Body

Once disassemble the

clamp to remove Pivot

Pin, Pivot Pin Fixing

Screw and Clamp

Tightening Screw,

then opne the clamp

arm.

Pillar

(smaller

diameter)

1 2

Shrnutí obsahu

Strany 1 - How To Assemble

Wheel Display Attachment WA-3 instructions manual(ver.1.0 2012/2)- 1 -Important Notices• For displaying a pair of bicycle wheel set only. Do not us

Strany 2 - Using WA-3

- 2 -Turn the Pivot Pin to align the thread hole and the hole on the clamp body.Screw the Clamp Tightening Screw into the Pivot Pin.ContactMINOURA Nor

Komentáře k této Příručce

Žádné komentáře

Minoura Wheel Display Attachment 3 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Pro jízdní kola Minoura Wheel Display Attachment 3. MINOURA Wheel Display Attachment 3 User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Pro jízdní kola Minoura Wheel Display Attachment 3